List: $52.50
(0) TAILPIPE REPAIR TOOL
TE3

For removing clamp grooves and truing damaged ends on exhaust pipes 1-5/8" to 2-7/16" in diameter. View Details

List: $293.25
(0) TAILPIPE EXPANDER KIT
TPS3510

The pipe stretcher is a convenient, inexpensive alternative to hydraulic pipe expanders. Use with an impact wrench to quickly stretch pipes. Can be used on the vehicle... View Details

List: $31.25
(1) EXHAUST HANGER REMOVER
EHR383

Works on all import and domestic car and truck exhaust systems that use the rubber hanger supports. Self-centering tip of the pliers easily removes the exhaust hanger bracket from the rubber hanger supports. Simply squeeze the handles to force the bracket from the rubber support. View Details

List: $151.95
(1) TAILPIPE EXPANDER
TPS344

Use with impact wrench to quickly stretch pipes. Two collet sets fit pipes from 1-5/8" to 2-7/16". Easily stretches all types of exhaust pipe. View Details

List: $78.15
(0) TAILPIPE EXPANDER
32750

Expands range of pipe sizes you can service. Fits pipes from 2-3/8" to 3-1/4". View Details

List: $71.45
(0) EXHAUST/ TAIL PIPE CUTTER
MST80A

Use tool to cut pipes 3/4" to 3-1/4" in diameter. 15 blades effectively cut pipe so only 1/4 turn is needed for a complete cut. For work in hard-to-reach places... View Details

List: $17.10
(0) 3/8 DR X 7/8" X80MM VACUUM SKT
SS7K4

Used to remove and install Oxygen sensors in most domestic and many imported vehicles. Socket designed with slot which allows clearance of wire. For use with 3/8" drive tool or 1" wrench. View Details

List: $45.45
(0) EXHAUST GROMMET PLIERS
EGP436

Removes exhaust components from rubber-style hangers. Self-locating forcing pin. Cushioned slip-resistant handles... View Details

List: $40.60
(0) PIPE END SHAPER
PS320

Insert the point of the cone into exhaust pipes to round them out. Reshape bent or flared pipes by placing big end over pipe. View Details

List: $41.50
(0) EXHAUST MANIFOLD JACKS
EX132

For reinstallation of the manifold on small block Chevrolet engines. Expands warped manifold so all bolt holes are accurately aligned. Includes 2 threaders. View Details

List: $19.25
(0) 1/2 DR X 27X 85MM INJECTOR SKT
SS7K3

Allows the removal and installation of thermal sensor switch on 1973-1977 GM vehicles. For use with Matco 1/2" Drive tools. View Details

List: $19.95
(0) 3/8" X 7/8"X30MM OFFSET OXG WR
SS7K7

Low profile for use in tight spaces. Designed to be used with 3/8" drive tool. View Details

List: $33.25
(1) DUAL DRIVE OXYGEN SENSOR WRENCH
MST123

Dual drive design for use with 1/2" Breaker Bar and 3/8" Square Drive Hand Ratchet. Six point design holds up to even the most stubborn, baked on oxygen sensors. Neck has a reduced size profile to fit sensors with a heat shield... View Details