List: $178.05
Set includes five pickle forks in a blow molded carry case; 11/16", 15/16", 1-1/8", 1-5/8" and 1-7/16" and two handles. The step design helps keep the tool from bouncing back when separating ball joints, steering dampeners, tie rods, pitman arms and other applications. Ten tools in one with five forks that are threaded to interchange with either of the two handles: one handle for hammering; one for use with an air hammer (.401 shank)... View Details
List: $83.65
For separating ball joints, tie rods, pitman arms and other uses. All forks are threaded to interchange with either handle. Includes: three forks 1-1/8", 15/16", 11/16" and two handles; one for hammering, the other for use with an air hammer (.401" shank). View Details
List: $94.35
Step design helps keep tool from bouncing back when separating ball joints, steering dampeners, tie rods, pitman arms and other applications. Steps can be resharpened if needed. Six tools in one: three forks (1-1/8", 11/16", 15/16") and two handles... View Details
List: $56.75
Axle Popper II is the air tool version of our original Axle Popper Wedge (MTAP71411). Like our original wedge, the Axle Popper II is tapered on both ends of the wedge with a 6" shaft to fit into your air hammer. Half shafts are sometimes difficult to break loose with a pry bar. Safer than using a pry bar, the Axle Popper II wedge forked end applies even pressure to both sides of the shaft for sure release of the shaft. View Details
