Showing 1 - 5 of 5
Features & Benefits
- 3 piece Set of Industrial, Tufted-Ended, Professional-Grade Bore Brushes
- Use on brake calipers, ports, bearings, blind and threaded holes and more
- Tube brush for cleaning inside threads, tubes and bores; tufted-end for cleaning blind holes
- High-density, strong bristles that last longer and clean better
- Long shank for access to deeper holes and hard-to-reach areas
- 1/4" hex shaft for adapting to standard driver handles
- Can be used with driver or low-speed drill; DO NOT EXCEED 600 RPM; NEVER USE IN REVERSE
- 10, 15 and 19mm Stainless Steel Brushes
Features & Benefits
- 6-Piece Bore Brush Set Features the Most Common Sizes
- Durable and abrasive bore brushes
- 6-piece set (8, 10, 12, 15, 17 and 19mm sizes)
- ¼" hex shank
- Available in: (#8081) Brass (#8080) Stainless Steel
- Do not exceed 600 rpm
- These brushes are meant for push, pull and clockwise use only.
- Do Not Turn Counterclockwise.
Features & Benefits
- Durable and abrasive bore brushes
- Includes sizes: 8mm, 10mm, 12mm, 15mm, 17mm and 19mm
- 1/4" Hex shank
- Use on ports tubes, bearings and other common wire brush applications
- Do not exceed 600 RPM
Features & Benefits
- Resiliant, flexible honing tool used to improve the internal surface finish while also being able to deburr a bore or cylinder
- Unique construction allows the tool to be self-aligning, selfcentering, and self-compensating for wear
- 120 grit generally provides an Ra Finish range of 35-50 Microinch and is excellent for mild steel, stainless steel and cast iron
- Overall tool length is 13.5 inches long and has a twisted wire stem for use in any collet, chuck or similar holding device
- Suggested speed range is between 600 - 900 RPM
- General feed rate of 150 - 250 ipm
Features & Benefits
- Resiliant, flexible honing tool used to improve the internal surface finish while also being able to deburr a bore or cylinder
- Unique construction allows the tool to be self-aligning, selfcentering, and self-compensating for wear
- 120 grit generally provides an Ra Finish range of 35-50 Microinch and is excellent for mild steel, stainless steel and cast iron
- Overall tool length is 13.5 inches long and has a twisted wire stem for use in any collet, chuck or similar holding device
- Suggested speed range is between 900 - 1000 RPM
- General feed rate of 150 - 250 ipm